For the 22kV Oil Immersed Power Transformer, we can produce capacity upto 420MVA. We use the best quality of raw material and advance design software to provide low noise, low losses, low partial discharge and high short-circuit impedance for power transformer.
Our power transformer are widely used in national grid, city grid, rural grid, power plant, industrial and mining enterprise, and petrochemical industry.
220Kv Transformer,220Kv Power Transformer,High Quality Power Transformer,Oil Immersed Transformer Hangzhou Qiantang River Electric Group Co., Ltd.(QRE) , https://www.qretransformer.com
(2) The outlet valve of the white earth pump is too large, the pump pressure is too low, the pump displacement exceeds the value specified on the nameplate, and the deviation from the working point is too much;
(3) the packing is pressed too tightly;
(4) The power supply voltage is too low and the current exceeds the rated value;
(5) The motor or pump is seriously different and the vibration is severe;
(6) The rotor and stator components in the pump are seriously rubbed;
(7) The motor rotor is turbulent, the position is not correct, the journal step and the bearing end face or the coupling and the oil seal cover are ground;
(8) The coupling cushioning damping rubber ring is too tight, and the pump front pushes the motor coupling and the bearing cover to wear;
(9) The balance plate of the white earth pump is not opened, the heavy grinding occurs in Botaibang, and the balance return pipe is hot;
(10) The radial clearance of the pressure relief sleeve or the balance disc is too small, the deflection is too large, and the operation is worn;
(11) When the pump starts, there is a serious internal fault, such as the mouth ring, the bushing falling off or the matching clearance is too small.
(12) The pump shaft is too rigid and deformed.
The ZYB external lubrication white earth pump can consume too much power in three ways.
(1) According to the situation on the spot, take corresponding measures in time to deal with it:
1 Get in touch with the power supply unit and adjust the power supply voltage to within the specified range;
2 Adjust the opening degree of the outlet valve so that it runs at the normal working point;
3 Properly control pump pressure and displacement to reduce motor running current;
4 Adjust the tightness of the packing gland.
(2) If the above measures cannot be eliminated, the pump should be stopped for inspection:
1Re-venting, draining the air inside the pump;
2 Check and adjust the lubricating oil pressure, and repair or replace the bearing with the clay pump.
3 Replace the coupling damping rubber ring;
4 repair or replace the balance plate;
5 Carry out the three-guarantee operation and repair and replace the damaged parts;
6 cooperate with the professional team to deal with motor faults.
(3) Suggestions and suggestions for improving the mismatch of pump units by the superior production management department and design unit:
1 replace the motor;
2 Impeller reduction or cutting impeller.
Reasons and treatment measures for excessive power consumption of ZYB external lubrication white earth pump
Reasons for the excessive power consumption of ZYB external lubrication white earth pump and treatment measures (1) The pump is not properly matched. The pump and replacement pump have improved pressure and displacement compared with the original pump, and the motor is used. The power is too small;